Check engine light came on started flashing car sputtered and ran ruff .

Question

I got code's P1706,PO301,PO302,PO33,PO135 . I changed the coil and ignition control module and car will not start . What are the code meanings and what makes it not get fired to plugs

Answer 1

P1706 A/T gear position switch (open)

P0301 Misfire number 1 cylinder

P0302 Misfire number 2 cylinder

P0135 02 sensor heater circuit malfunciton Bank 1 Sensor 1

What gives spark is the ignition coil and the ignition control module ( sometimes reffered to as the ignitor).If the vehicle has a tachtometer it can use this as a indication if the igntion system is working , when you are cranking the engine and the tach bounces (which will be very small) you can be sure you have a working ignition system, If the igntion system is working you now have to check the cap making sure the button is there , the rotor did not slip out of position. . If you do not have a working igntion system you need to check it for power. From the ignition switch power is given to the coil, from fuse 9 located in the under dash fuse, On the positive side with key on you should have battery voltage with key on engine off