0 like 0 dislike
1.2k views
by (101 points)

Iv replaced the o2 sensor and I'm still getting code 41-02

Vehicle: 1997 Honda civic y7 1.6 sohc

1 Answer

0 like 0 dislike
by (13.4k points)
You treat this code as a P0135 which means electrical problem in the heated 02 sensor. Honda its going to vary from model to model , most of it uses fuse 9. and some uses the same fuse for the a/c clutch.
by (101 points)
0 0
Thanks I'll give those a look.. when I looked at the data stream for that it said it was off so going it is a fuse
by (101 points)
0 0
Ok so I checked all my fuses #9 is to the ignoring coil  which is good... I looked for the AC clutch fuse but don't see one i did find the AC condenser fuse was blown and i changed it cleared code.. cel came back on about 3 seconds later scanned again and now say same code but now it s1 heater failure or b2 s1 heater circuit.. I also looked at data stream for both s1 and s2  and seen voltage on s1 was 3.89 a t idle and 2 was 1.06.. is this correct or wrong

Related questions

0 like 0 dislike
1 answer 4.3k views
0 like 0 dislike
1 answer 1.1k views
0 like 0 dislike
1 answer 3.9k views
asked Sep 29, 2018 by Lili (101 points)
0 like 0 dislike
1 answer 159 views
asked Apr 4, 2018 by anonymous

36.2k questions

32.2k answers

1.3k comments

22.8k users

Need A Repair Shop?
Find local automotive repair shops in your area.
Does your car have Safety Recalls? → Check here
...