0 like 0 dislike
5.7k views
by

Can't find definition for code P11DB. What is wrong with my truck? Thanks

Vehicle: 2013 Chevrolet Silverado 6.6 liter Duramax

1 Answer

0 like 0 dislike
by (13.5k points)

Hi there,

Circuit/System Description 

The reductant system uses two nitrogen oxide (NOx) sensors to monitor the amount of NOx in the engine's exhaust gas. The first sensor is located at the outlet of the turbocharger and monitors the engine out NOx level. The second NOx sensor is located between the selective catalytic reduction (SCR) and the diesel particulate filter (DPF) and monitors NOx levels downstream of the SCR. The second NOx sensor also provides the engine control module (ECM) with information on the exhaust oxygen level during DPF regeneration.

Each NOx sensor contains a sensing cell, a pumping cell, and a heater. A sample of exhaust gas passes through a diffusion gap between the sensing cell and the pumping cell. The NOx sensor maintains a constant reference voltage across the sensing cell. An electronic circuit within sensor controls the pump current through the pumping cell in order to maintain a constant voltage in the sensing cell. The amount of current required to maintain the reference voltage in the sensing cell is proportional to the concentration of NOx in the exhaust.

The ECM varies the amount of diesel exhaust fluid (DEF) or reductant added by varying the reductant injector duty cycle in response to changes in engine exhaust out NOx levels.

The smart NOx sensors consist of two components, the NOx module and the NOx sensor element that are serviced as a unit. A circuit or performance condition with a NOx sensor is detected by the NOx sensor module. The smart NOx sensor module communicates the condition to the ECM over the serial data line. The ECM sets a DTC when a serial data message is received from the NOx sensor module.

Conditions for Running the DTCs 

P11DB 
 

 

  • DTCs P064C, P163C, P2200, P2205, P220A, P220B, U029D and U029E are not set.
  • The exhaust gas temperature (EGT) sensor 1 is greater than 95°C (203°F).
  • The engine speed is greater than 600 RPM.
  • The battery voltage is greater than 11 V.
  • The DPF regeneration is not active.
  • The DTCs run continuously when the above conditions are met.

Related questions

1 like 0 dislike
1 answer 348 views
0 like 0 dislike
2 answers 851 views
0 like 0 dislike
1 answer 1.4k views
0 like 0 dislike
1 answer 167 views

36.2k questions

32.2k answers

1.3k comments

22.8k users

Need A Repair Shop?
Find local automotive repair shops in your area.
Does your car have Safety Recalls? → Check here
...