What car problem What needs to change for it to work properly and disappear bulb inconvenience
meta-info header:Error Codes file version:1 type:5 time:1430901687082 name:Trouble Codes codes:P0453, codes_p:P0453, codes_raw:7E9024300;;7E80443010453;;;; codes_p_raw:7E9024700;;7E80447010453;;;; ***** Error Codes P0453 Evaporative Emission System Pressure Sensor/Switch High Ambient air temperature (AAT) 93 °F Catalyst Temperature Bank 2, Sensor 1 (CT21) 714.0 °F Accelerator pedal position F (APPF) 17.25 % Distance traveled since codes cleared (CD) 0 mi Accelerator pedal position E (APPE) 27.84 % PIDs supported [41 - 60] 11111110111100000000000000000000 Commanded throttle actuator (CTA) 3.52 % Barometric pressure (BP) 0.9279368213228035 Atm Short term fuel % trim Bank 1 (STFT1) 0.0 % Relative throttle position (RTP) 2.35 % Bank 2, Sensor 1: O2 voltage, Short term fuel trim (STFT212) [D@43ffa4d0 Commanded evaporative purge (CEP) 0.0 % Absolute load value (ALV) 16.07843137254902 % Engine coolant temperature (ECT) 190 °F Run time since engine start (RunTime) ٠:٠٠:02d s Vehicle speed (Speed) 0 MPH Long term fuel % trim Bank 2 (LTFT2) 0.78 % Long term fuel % trim Bank 1 (LTFT1) 0.78 % Catalyst Temperature Bank 1, Sensor 1 (CT11) 714.0 °F Bank 1, Sensor 2: O2 voltage, Short term fuel trim (STFT122) [D@43ff6730 MAF air flow rate (MAF) 6.15 g/s Absolute throttle position B (ATPB) 17.64 % Calculated engine load value (EngineLoad) 22.74 % Command equivalence ratio (CER) 1.0 N/A Timing advance (TA) 12.5 ° Engine RPM (RPM) 712 rpm
Short term fuel % trim Bank 2 (STFT2) 0.0 % Throttle position (TP) 14.9 % Control module voltage (CMV) 13.711 V Bank 1, Sensor 1: O2 voltage, Short term fuel trim (STFT112) [D@43ff2060 PIDs supported [21 - 40] 00000000000001111110000000011001 Bank 2, Sensor 2: O2 voltage, Short term fuel trim (STFT222) [D@43ffead0 Intake air temperature (IAT) 131 °F Fuel system status (FSS) Openloop:insufficientenginetemperature Evap. System Vapor Pressure (VP) 164.5014807502468 Atm*E-03 Accelerator pedal position D (APPD) 18.03 % Monitor status this drive cycle (DCS) 00000000011101110110000101100101 Fuel Level Input (FLI) 36.07 %
=================== Pending Codes P0453 Evaporative Emission System Pressure Sensor/Switch High
P0453 Evap pressure sensor switch High Irregardless if the FTP sensor is within specs or works, If the sensor was short to signal the MAF would register lower, and so would the IAT.Since both these sensor are within specification , suspect the ECM.
Circuit high code occur when there is a open or disconnection of the sensor. The job of the ECM is tolook for open circuit, short circuit, and grounds, Here is a speed sensor with a P0501 circuit high code condition. what was found was a broken connection
33.7k questions
32.5k answers
1.3k comments
23.0k users