0 like 0 dislike
919 views
by

2004 hyundai santa fe 4wd 3.5L

Engine light for a day, car still ran great. the engine codes that came up are p0441 and p1194

Next day car stalled on highway, tried to restart and it would turn over and not start. 5 minutes later it started and I drove home. Next day I drove it on and off all day. Finally it died again, restarted after 5 minutes, then continued to repeat this all the way home. Did some research and replaced the PCSV valve. Now it starts and after 3-5 seconds it dies, does not restart easy either. Any clue?

Vehicle: 2004 hyundai sante fe 4wd 3.5L

1 Answer

0 like 0 dislike
by (13.5k points)
P1194 ETS limphome - TPS Mal

P0441 EVAP emission incorrect purge flow

P1194 and P0441 will not cause the vehicle to stall out, Check the fuel pressure, the specification are 38 psi at idle.If you have P1194 you would have a limp home mode where the throttle motor is set at one position to prevent you from stalling out,
by
0 0
Thank you for answering Reynaldo,
So are you suspecting the fuel pump? And if so, could that send the failing codes I recieved? Already replaced the pcsv.  Fuel pump may make sense, I dont really hear it engage when I turn the key, just a click.

Related questions

33.7k questions

32.5k answers

1.3k comments

23.0k users

Need A Repair Shop?
Find local automotive repair shops in your area.
...