0 like 0 dislike
6.6k views
by

I replaced the sensor behind the Crankshaft pulley , but still getting the code . My Haynes manual says there is a second Crankshaft Sensor , I think , on the " back side " of the block , next to the fire wall . I can not find the sensor ? Any way to tell which sensor is generating the code ?Thanks

Vehicle: 1996 Chevy Lumina 4 door sedan 3.1L
by
0 0
You are 100% correct , sensor A is the one behind the crankshaft pulley .  Sensor B is the one on the back side of the engine .

     I went to replace the sensor  A electrical connector on the wiring harness .  I found one of the 3 little wires to the old electrical connector broken .

     I spliced th the new connector & cleared the codes .  Check engine lite has not come back on .   :-)  

     Praise the Lord

God bless
wyr

1 Answer

0 like 0 dislike
by (8.3k points)

The P0336 Code should be for the one behind the crankshaft pulley, but I heard in some case could also be cause by the one on side. Here is an image of the location.

1996 Chevrolet Lumina Crankshaft Position Sensor Location

Related questions

1 like 0 dislike
1 answer 1.2k views
0 like 0 dislike
1 answer 368 views
asked Apr 10, 2018 by Victor
1 like 0 dislike
1 answer 478 views
1 like 0 dislike
2 answers 523 views
0 like 0 dislike
1 answer 454 views

36.2k questions

32.2k answers

1.3k comments

22.8k users

Need A Repair Shop?
Find local automotive repair shops in your area.
Does your car have Safety Recalls? → Check here
...