Question

I have a 2010 Chevrolet Cobalt 4 Cyl. with diagnostic codes p0010, p0011. what could be the problem?

Answer 1

These codes are normally caused by a low oil level. The codes are for the intake cam actuator solenoid. Basically the intake cam is not advancing when it should and it sets the code. This could be low oil, the solenoid itself or a problem with the wiring. The P0011 is just a code that shows it out of range. Repair the solenoid to resolve both codes.

Answer 2

The P0010 and P0011 codes indicate a problem with the Intake Camshaft Position Actuator Solenoid Valve. Begin by checking the engine oil level and quality. If necessary, change the engine oil and filter. If the problem persists, replace the Intake Camshaft Position Actuator Solenoid Valve to address the issue. For more information about the codes, visit the following links:

P0010 CHEVROLET - Intake Camshaft Position Actuator Solenoid Control Circuit
Read more: https://www.autocodes.com/p0010_chevrolet.html

P0011 CHEVROLET - Intake Camshaft Position System Performance
Read more: https://www.autocodes.com/p0011_chevrolet.html