B1019 Chevrolet Code - SDM System Configuration Error
Quick Answer
The Inflatable Restraint Sensing and Diagnostic Module (SDM) monitors the number of safety components installed on the vehicle. Common causes include Program Inflatable Restraint Sensing and Diagnostic Module (SDM), Faulty Inflatable Restraint Sensing and Diagnostic Module, Inflatable Restraint Sensing and Diagnostic Module harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- B1019 Chevrolet indicates SDM System Configuration Error.
- Common causes
- Common causes include Program Inflatable Restraint Sensing and Diagnostic Module (SDM), Faulty Inflatable Restraint Sensing and Diagnostic Module, Inflatable Restraint Sensing and Diagnostic Module harness is open or shorted.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code B1019 Chevrolet Description
What are the Possible Causes of the DTC B1019 Chevrolet?
- Program Inflatable Restraint Sensing and Diagnostic Module (SDM)
- Faulty Inflatable Restraint Sensing and Diagnostic Module
- Inflatable Restraint Sensing and Diagnostic Module harness is open or shorted
- Inflatable Restraint Sensing and Diagnostic Module circuit poor electrical connection
How to Fix the DTC B1019 Chevrolet?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
Diagnostic Trouble Code (DTC) B1019 can be set after the Inflatable Restraint Sensing and Diagnostic Module (SDM) has been replaced and/or reprogrammed before the setup procedure is completed. The setup procedure cannot be completed if DTC B1019 is set as current or history. If a short or open is detected in a deployment circuit prior to the setup procedure being performed, the inflatable restraint sensing and diagnostic module will set DTC B1019.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B1019 Chevrolet code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the B1019 Chevrolet code?
Need more information on how to fix the B1019 Chevrolet code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the B1019 Chevrolet code diagnosed by a professional: Find a repair shop in your area
Information for Specific Chevrolet Models
- B1019 2014 Chevrolet Silverado — SDM System Configuration Error
- B1019 2015 Chevrolet Silverado — SDM System Configuration Error
- B1019 2016 Chevrolet Silverado — SDM System Configuration Error
- B1019 2017 Chevrolet Silverado — SDM System Configuration Error
- B1019 2018 Chevrolet Silverado — SDM System Configuration Error
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Frequently Asked Questions about B1019 Chevrolet Code
1. What does the OBDII code B1019 mean in a Chevrolet vehicle?
B1019 indicates a "SDM System Configuration Error," which means there is a mismatch or corruption in the settings of the Sensing and Diagnostic Module (SDM), often related to airbag or crash sensor systems.
2. What are common symptoms of the B1019 code in a Chevrolet?
Symptoms typically include an illuminated airbag warning light, inability to clear the code, or malfunctioning airbag system.
3. What causes the B1019 code to appear in a Chevrolet?
The code can be triggered by incorrect SDM programming, a failed SDM module, wiring issues, or replacing the SDM without proper configuration.
4. Can a dead battery cause the B1019 code on a Chevrolet?
Yes, a dead or weak battery during system updates or resets can corrupt the SDM configuration and trigger the B1019 code.
5. How is the B1019 code diagnosed in a Chevrolet vehicle?
Diagnosis involves scanning the vehicle with a compatible OBDII scanner, checking for SDM programming errors, and inspecting associated wiring or connectors for damage.
6. Can the B1019 code affect airbag deployment in a Chevrolet?
Yes, this code can prevent proper airbag system function, potentially disabling airbag deployment during a collision.
7. How can the B1019 code be fixed in a Chevrolet?
Fixes include reprogramming the SDM module with factory settings, replacing the SDM if faulty, or repairing any damaged wiring or connectors.
8. Do I need specialized tools to clear the B1019 code in a Chevrolet?
Yes, clearing the B1019 code often requires a GM-compatible scan tool or software to properly reprogram or reset the SDM system.
9. Is it safe to drive with the B1019 code on a Chevrolet?
It is not recommended, as the airbag system may not function correctly, posing a serious safety risk in the event of an accident.
10. Can a used SDM module cause the B1019 code in a Chevrolet?
Yes, installing a used SDM module without reprogramming it to match the vehicle's configuration can trigger the B1019 code.
Discuss the causes and fixes for B1019 Chevrolet OBDII Code
Code B1019 Chevrolet comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
