Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost of diagnosing the U2104 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. If no communication is detected on CAN serial data circuit, the Diagnostic Trouble Code (DTC) is set. A total non-communication condition may be caused by a short to battery or voltage on any of the CAN circuits or a short between the CAN high and low circuits.
The following modules communicate on CAN serial data bus: The Body Control Module (BCM), The Electronic Brake Control Module (EBCM), The Engine/Powertrain Control Module (ECM/PCM), and The Transmission Control Module (TCM).
Need more information on how to fix the U2104 code? Get Access to Factory Service Manuals
Get the u2104 code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the u2104 code? Have you replaced any parts?
Any information is appreciated. Thanks