U2104 BUICK Code - Controller Area Network Bus Reset Counter Overrun
|U2104 BUICK code possible causes
- Faulty Control Module
- Control Module harness is open or shorted
- Control Module circuit poor electrical connection
|How do I fix the U2104 BUICK code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the U2104 BUICK code
Labor: 1.0The cost of diagnosing the U2104 BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are U2104 BUICK code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|U2104 BUICK code descriptionModules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. If no communication is detected on CAN serial data circuit, the Diagnostic Trouble Code (DTC) is set. A total non-communication condition may be caused by a short to battery or voltage on any of the CAN circuits or a short between the CAN high and low circuits.
The following modules communicate on CAN serial data bus: The Body Control Module (BCM), The Electronic Brake Control Module (EBCM), The Engine/Powertrain Control Module (ECM/PCM), and The Transmission Control Module (TCM).
|Need more information with the U2104 BUICK code?Need more information on how to fix the U2104 BUICK code? Get Access to Factory Service Manuals
|Need help with a U2104 BUICK code?Get the U2104 Buick code diagnosed by a professional: Find a repair shop in your area
|U2104 BUICK code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U2104 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks