My 2008 Honda Accord V6 3.5L hits gears 1 and 2

Question

Hi, good, I have a problem with my 2008 Honda Accord V6 3.5L from one day to the next the changes began to change abruptly or strongly, so to speak, every time I place direct it hits a strong jerk, just like when it goes to second I have read that they are the solenoids that go outside the box I would like to know if someone has happened and has been able to solve the issue I already put a scanner in it and of all the solenoids that appear it says that the D does not work it does not throw parameters or anything hopefully someone who can help me It happened to him and I solve it please thank you

Answer 1

In the end, friends, it was a problem with the parameters of the box, it was a matter of re-scanning and resetting the
Factory parameters for the changes and the selector to pass the changes at the corresponding rpm I hope it helps someone, regards

Answer 2

Unfortunately, without an engine code, it is a bit difficult to diagnose the problem. It requires you to do some testing to find out what is causing the problem. There are no common issues that will cause a hard shift on the 08 Accord. My only recommendation is to check the transmission fluid and make sure the fluid is at the proper level and clean. Change the fluid if necessary. If the problem persists and you still have no codes, then you need to take your vehicle to a transmission shop for further inspection.

Comments

Hello friend, the transmission oil is new and changed about 1 month ago and it is a genuine Honda original. The problem happened from one day to the next and I still haven't been able to find the problem today. I'll see if the scanner shows me any other problem since since it doesn't turn me on check it doesn't throw me an error or anything on the dashboard I still can't know what it is