Why won't my 2002 sunfire start when I got gas and spark

Question

I got spark and fuel but the car just cranks and won't start

Answer 1

The Anti-Theft see if the light on for it, You may wan to do a 30 minute learn procedure included is the instruction for it

30 Minute Learn Procedure

TOOLS REQUIRED
None
 

1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON. The vehicle will not start.
3. Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.
4. Turn OFF the ignition, and wait 5 seconds .
5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes . The vehicle is now ready to relearn the PASSLOCK(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.

IMPORTANT: The vehicle learns the PASSLOCK(TM) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.
 

1. Start the engine. The vehicle has now learned the PASSLOCK(TM) Sensor Data Code and/or password.
2. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.