Where do I find the fuel tank purge solenoid for a 2012 Mazda 6 3.7 liter engine

Question

I am showing a P1450 code but I can't locate the solenoid to replace it.  Any help and possibly pictures would be appreciated.  Thank you.

Answer 1

P1450 Unable to bleed up fuel tank vacuum

Here use this TSB the problem with this code is the purge solenoid. If you take a tight turn and there is a slight miss at the engine it more likely the purge solenoid. also when at idle you can probly hear the purge with its constant gulping this would indicate that it is leaking Here a TSB for this code that you set . it only a partial TSB

Bulletin No: 01-012/14

Last Issued: 05/15/2014

Subject:

CHECK ENGINE LIGHT ON WITH DTC P1450:00

BULLETIN NOTE

*^	This bulletin supersedes the previous bulletin 01-012/14 issued on 05/14/14. The WARRANTY INFORMATION has been revised.
^	Changes are noted below beside the change bar in Red or by asterisks.*

APPLICABLE MODEL(S)/VINS

2009-2013 Mazda6 3.7L vehicles produced before March 31, 2012

DESCRIPTION

Some vehicles may experience the Check Engine Light ON with DTC P1450:00 (Unable to bleed up fuel tank vacuum) stored in memory. This concern may be caused by the purge valve, which has been modified to eliminate this concern.

Customers having this concern should have their vehicle repaired using the following repair procedure.

REPAIR PROCEDURE

1.	Verify customer concern.
2.	Replace the purge solenoid valve with the modified part according to the instructions on MS3 online or the Workshop Manual (section 01-16 PURGE SOLENOID VALVE REMOVAL/INSTALLATION).
3.	Verify the repair.