P0183 2005 NISSAN QUEST - WHERE THIS SENCOR LOCATED ?. HOW CHANGE THIS

Question

My 2005 Nissan Quest have check engine light , code showing P1083-P1013 .
need replacement of Fuel Temperature Sensor and Mass Air Flow Sensor. I Know where is Mass air Flow Sensor but i could not find Fuel Temperature Sensor , I need help to fine that ,where is FTS located. My Van Fuel economy is too bad ,and i feel my Engine still not enough warm, like am i driving cold engine. Please help me.

Answer 1

The fuel temp sensor is part of the fuel pump module inside the fuel tank.

P1013 is not for the maf sensor. It is for the heater on the bank #1 A/F sensor, this is also known as the O2 sensor. This is the sensor in the exhaust manifold closest to the firewall.

P1083 is not a valid code.

Comments

Thanks, you are right my bad, the second code is not P1013 , it,s P0113. plus Fuel Temp Sensor is the part of fuel pump or is a separately Huck some where in Tank ?. I can replace that without take off Tank completely ?. What P0113 and P0183 are related with each others?. I,ll much appreciated.

---

P0113 is for the intake air temp sensor. This is part of the maf sensor. Makes sense why you were talking about the maf sensor now. Chances are you will need to replace the maf sensor to resolve the IAT sensor code. The FTS is part of the fuel pump. You will have to remove the fuel tank and the fuel pump.

---

I replaced whole new fuel pump, i clear is code, drove 50 miles after i toke my van for emission but it still failed showing P0113-P0183, after replace fuel pump and FTS one thing is clear my van no have fuel pump or fuel temperature sensor problem at this time (because of new fuel pump) problem is still some thing else , what i can do next, any idea ?.

---

OK, the P0113 is for the intake air temp sensor, this is part of the mass air flow sensor located on the duct work to the throttle.
If you still have the FTS code, you need to check continuity on the red/blue stripped wire from the ecm to the fuel pump.

---

there have two  connecter plug in ECM  with 100,s of wires , which connecter is related with Fuel pump wires small one or bigger ?. what fuel temp sensor and mass air flow sensor need re collaboration ECM (Re programing ) ?.