P0320 and p2106 codes ford freestyle 2005 failsafe engine mode

Question

Car goes into failsafe mode after driving 30 miles and over. Speed lost and stepping on gas won't make it budge. Turn car off and back on it runs for 2 mins then the process starts all over. I feel a huge jerk before it goes into failsafe engine mode. Tool light then check engine light comes on. Replaced throttle body, crank and cam shaft sensor along with new coils and spark plugs.

Answer 1

P0320 Ignition engine speed input circuit malfunction

P2106 Throttle actuator Forced limit power

P2106 is just a informative code, P0320 you stalled, Certain characteristic event will help pin point the problem, During early morning start up is it easy to start up? when you stall does it easily start up? during cruising and you do a sudden acceleration does it stall out then?  The Freestyle is a good vehicle, one of the most popular component to fail is the fuel rail pressure sensor. Drive it normal and see if a P0193 set, if it does replace the fuel rail pressure sensor.

​ Here a fuel pump fuel strainer separated this caused sudden stalling and unpredicated stalling, with no code being set, what gave this symptom away was the sound of the fuel pump was making before a stall out,and it would not start up right away

Comments

since the codes appeared the start up has been rougher then normal but  the car starts up right away. No noise that really alarmed me. When I accelerate I hear a loud vooom as the car jerks to high speed then loose power instantly. Steering wheel locks and tool light with failsafe engine light comes on. The car starts but just gives out on me quickly. I noticed now when I pump gas while car is off a clicking and jerking noise happens. No problems with the car intaking the gas and the pump doesn't shut off. Don't know if that has anything to do with it but these are all problems occurring

---

Sorry no p0193 sensor been this way for 2 weeks , the same code p3020 and p2106

---

P0320 is the input engine speed sensor, yes the vehicle would stall, but in most case will not startup, You can set a P0320 when the CKP has a poor connection, The way the engine stall and the P2106 and the wide open throttle event, it points to the TPS.there are  updated TPS for P2106.