0 like 0 dislike
295 views
by
I put a 99' elantra 2.0 dohc head on 05'Tucson  2.0 dohc.the new head doesnt have the cylindrical cvvt sensor or oil temperature guage on front right side of head.This head does not have a spot even machined out for them.so the wires that plug into them are just hanging loose and not hooked to anythin. Its setting off code P0077..how can i loop them to shut check engine light out and not harm anything else?i was thinking of looping the cvvt plug from the front of engine to the 2 wire sensor located on rear of block below the a/c compressor The guage in car is reading temperature though so i assume if i somehow loop the cvvt plug the check engine light and code will go out.
Vehicle: 2005 Hyundai Tucson 2Wd

Please log in or register to answer this question.

Related questions

0 like 0 dislike
1 answer 3.3k views
asked Apr 20, 2017 by majid
0 like 0 dislike
1 answer 345 views
1 like 0 dislike
2 answers 494 views
1 like 0 dislike
1 answer 301 views

36.2k questions

32.2k answers

1.3k comments

22.8k users

Need A Repair Shop?
Find local automotive repair shops in your area.
Does your car have Safety Recalls? → Check here
...