P0077 Hyundai - how do i loop it .

Question

I put a 99' elantra 2.0 dohc head on 05'Tucson  2.0 dohc.the new head doesnt have the cylindrical cvvt sensor or oil temperature guage on front right side of head.This head does not have a spot even machined out for them.so the wires that plug into them are just hanging loose and not hooked to anythin. Its setting off code P0077..how can i loop them to shut check engine light out and not harm anything else?i was thinking of looping the cvvt plug from the front of engine to the 2 wire sensor located on rear of block below the a/c compressor The guage in car is reading temperature though so i assume if i somehow loop the cvvt plug the check engine light and code will go out.