P0344 Dodge - i replaced both cam position sensor and crankshaft sensor and this code still comesup.

Question

Replaced both sensors cam and crankshaft sensors with OEM parts and reset the code. The code p344 still comes up. it runs normal up until i give it gas then it shuts off. It turns back on but only after i park it and starts right up.

Answer 1

P0344 Camshaft position intermittent

Disconnect the camshaft sensor, and retest. Even with this  code , camshaft sensor does not stall the engine it make it run rough, The camshaft position sensor and the CKP share the ECM ground. disconnect it if it stall out you may need to look into the harness of the ECM crankposition sensor and cam position sensor. and measure its ground and its refrence voltage. If its ground is greater than 0.2 volts you need a ECM