Hi there, I have three codes I need help fixing: p1000, p0455, and u1262

Question

One is an EVAP leak, one is something about a test isn't complete and the final one might be related to the ABS module. Just want some advice before I start trying to fix it.

Answer 1

P1000 Monitor testing not complete

P0455 Evaporative control system leak detected (no purge flow or large leak)

U1262 Anti lock brake control module

P1000 you get this when you recently clear the CK ENG LT, and the monitor needs to be reset, this is important if you are going for the emission test. where the monitor has to be complete.As for U1262 is the brake fluid low or the brake level sensor in the master cylinder causing the brake light to go on? If it is not , the only known fix is to replace the ABS module. U1262 is a communication failure of the ABS module. P0455 Where the fuel fill hose connects to the fuel tank it tends to crack at that area where is connects to the fuel tank , this should be the first inspection , If anything you can probably smell raw fuel or can just be the fuel cap being worn