0 like 0 dislike
273 views
by

Engine is brand new Jasper Hemi 5.7 long block. Replaced the Total Integrated Power Module, Trans Control Module, Traction Control Module, oil pressure sensor, power steering pump and hoses, front drive axle rods, key ignition, all in the few months. Problems with all dash lights coming on/off, vehicle stalling for no reason, (in traffic, etc.). Now cannot drive vehicle as the ETC light comes back on after gas-pedal reset. Ignition cycle shows P2100 code only. Could this just be the battery (5 yrs old)?

Vehicle: 2006 Jeep Commander 5.7 Hemi

1 Answer

0 like 0 dislike
by
the problem is with the throttle body or the wiring.

try to clean it ( it may be dirty) and do an ETC relearn. If that does not help there are a handful of tests to do to check the wiring.

Related questions

0 like 0 dislike
1 answer 383 views
0 like 0 dislike
1 answer 487 views
0 like 0 dislike
1 answer 242 views
asked Apr 23, 2017 by anonymous
0 like 0 dislike
1 answer 1.3k views
asked Mar 19, 2017 by Matthew
1 like 0 dislike
1 answer 414 views

36.2k questions

32.2k answers

1.3k comments

22.8k users

Need A Repair Shop?
Find local automotive repair shops in your area.
Does your car have Safety Recalls? → Check here
...