I can't seem to find the code p0113 for a 2006 Suzuki forenza base manual transmission

Question

I took my car to the automechanic shop to have the water pump replaced now the check engine light is coming on the mechanic said the 2006 Suzuki forenza base sedan manual transmission is coding p0113 can't find that code in the Suzuki code list

Answer 1

Hi there,

The code is all about the intake air temp sensor.

Circuit Description 
The Intake Air Temperature (IAT) sensor uses a thermistor to control the signal voltage to the Engine Control Module (ECM). The ECM supplies a 5 volt reference and a ground to the sensor. When the air is cold, the resistance is high; therefore the IAT signal voltage will be high. If the intake air is warm, resistance is low; therefore the IAT signal voltage will be low.

Conditions for Setting the DTC 

 

• IAT is less than -38 degrees C (-36 degrees F) .
• Vehicles speed is less than 25 km/h (16 mph).
• Engine run time is greater than 120 seconds.
• Engine Coolant Temperature (ECT) is above 70 degree C (158 degrees F) .
• Calculated air flow is less than 15 g/second.
• DTC P0502, P0117 and/or P0118 are not set.