0 like 0 dislike
382 views
by

I removed and clean the throttle body and the car idle rough and high in park and neutral

Vehicle: 2008 Pontaic G6 4 clinder

1 Answer

0 like 0 dislike
by
you will have to do idle relearn procedure
 
1. Start and idle the engine in PARK for 3 minutes.
2. With a scan tool, monitor desired and actual RPM.
3. The ECM will start to learn the new idle cells and Desired RPM should start to decrease.
4. Ignition OFF for 60 seconds.
5. Start and idle the engine in PARK for 3 minutes.
6. After the 3 minute run time the engine should be idling normal.
Important: During the drive cycle the check engine light may come on with idle speed DTCs. If idle speed codes are set, clear codes so the ECM can continue to learn.
If the engine idle speed has not been learned the vehicle will need to be driven at speeds above 70 km/h (44 mph) with several decelerations and extended idles.
7. After the drive cycle, the engine should be idling normally.
If the engine idle speed has not been learned, turn OFF the ignition for 60 seconds and repeat step 6.
8. Once the engine speed has returned to normal, clear DTCs.

Related questions

0 like 0 dislike
1 answer 697 views
0 like 0 dislike
1 answer 503 views
asked Oct 30, 2018 by
0 like 0 dislike
1 answer 2.2k views
0 like 0 dislike
1 answer 342 views

33.7k questions

32.5k answers

1.3k comments

23.0k users

Need A Repair Shop?
Find local automotive repair shops in your area.
...