P0344 Dodge - neon 04.. engine light on cant go over 2000 rpm without jerking.

Question

3rd sensor replaced n 5 yrs. I only have 63523 miles ecm been reset 3 times..check tran fluid.good.oil good took 2 firestone left with no answers, still same issue, light on &had to pay $103!

Answer 1

P0344 Camshaft position sensor intermittent

Some of the causes of why this codes set are , loss of 5 volt supply circuit to the camshaft position sensor,camshaft psoition sensor itself,camshaft postion sensor shorted,This can also come from a worn timing belt, In most cases a worn timing belt will code cam and crank correlation.but it doesnt have to code up.The most probable cause and condition of your vehicle is a loss of 5 volt reference, which affects both cam sensor and crank sensor, P0344 is a common code with Dodge / Chrysler where the ECM is at fault. For now replace the ASD (automatic shut down)  relay, and see if that helps which is located in the engine fuse relay box