0 like 0 dislike
1.7k views
by

car runs fine sometimes other times right from start up the check engine light comes as well as the traction light then in the diplay the low power,service traction and service esc . you can shut it off, it might take up 4 trys to get the low power off then might drive for a bit before it happens again I have put a new accelertor pedal in no change

Vehicle: Chevy hhr 2.2 auto trans

1 Answer

0 like 0 dislike
by

I've seen two service bulletins that say check the harness that might have corrosion or that might be rubbing on axel/driveshaft

 

NHTSA Item Number: 10032332 
Service Bulletin #: SB-09-06-03- 
Replacement #:  
Vehicle/Equipment Make: GMC 
Vehicle/Eqipment Model: HHR SS 
Model Year: 2009 
Mfg Component Code: 114000 ELECTRICAL SYSTEM:WIRING 
Date of Bulletin: 2011-12-01 
Date Added: 2010-03-05 
Summary: GM/HUMMER/SAAB: INTERMITTENT ILLUMINATION OF MIL, SERVICE LAMPS, SERVICE MESSAGES, OR DTC SET BY VARIOUS CONTROL MODULES-DIAGNOSING AND REPAIRING FRETTING CORROSION (DISCONNECT AFFECTED CONNECTOR AND APPLY DIELECTRIC LUBRICANT). *PE UP  

or 

The P069E could be a wiring harness rubbing to ground on the front drive shaft.Look at this bulliten.

#PIP3809C: SES Light - Inspect wire Harness For Short On Front Drive Shaft - (Feb 12, 2009)


 

Related questions

0 like 0 dislike
1 answer 743 views
asked Jun 19, 2017 by
0 like 0 dislike
1 answer 986 views
0 like 0 dislike
1 answer 1.8k views
0 like 0 dislike
0 answers 459 views

33.7k questions

32.5k answers

1.3k comments

23.0k users

Need A Repair Shop?
Find local automotive repair shops in your area.
...