P1211 FORD - on 1995 f250 diesel

Question

1995 powerstroke engine codes p1200 and p1211

Answer 1

P1211 Injector control pressure sensor above/below desired

P1200 Injector control circuit

If you have a ICP code your vehicle the vehicle wont start, If it is a no start disconnect the ICP the ECM should go to failsafe management.you basically need to check oil pressure, this sensor is located into the left front cylinder head.The IPR is located top of engine on lower driverside of the fuel filter housing.These code could of been set of due to low or no fuel