P0505 DODGE - WILL THIS CAUSE ERATIC STALLING AND NO RESTART

Question

Have replaced cap,rotor,plugs,wires, coil; code used to be PO351, used to stall when turning Drives ok 1-2days and again same thing happens Replaced the distributor cap and rotor when it will not start after trying for 20-30 minute and engine will start. Adjusting the 3 plugs on the PCM (power control module - the brain) will most of the time allow engine to restart. Have put a small amount of di-electric grease in the female plug area (maybe the male plug is worn? there fore smaller and not allowing electrical contact?) All of these things have allowed he engine to start and run with no problems from 10 minutes to 2 days recently. Although, I drove from east texas to ny with no problems while this problem existed. (3 days for that trip) I recently found out that there is a pick-up sensor and I am going to replace that this friday 10-20-12

Answer 1

The P0505 code means that the idle is not set to factory specs. In you case looks like after replacing all the parts the engine idle is either too low or too high. If the engine is running OK, you should just try adjusting the idle and clearing the code first, before replacing any other parts.