AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - P1061

P1061 Code - Cylinder 1 Oil Supply Solenoid Valve Stuck

- Code Popularity: 11,284 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1061?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Variable Valve Actuator (VVA) Solenoid
  • Variable Valve Actuator Solenoid harness is open or shorted
  • Variable Valve Actuator Solenoid circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC P1061?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1061 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1061 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1061 Description

Multi-Air is an electronically controlled variable intake valve phase and lift system. Unlike conventional intake valve phase and lift system which controls all the cylinder intake valves simultaneously and in the same proportion; Multi-Air, through the use of an electronically controlled hydraulic link between the camshaft and intake valve, allows for each intake valve to be controlled independently. The valve lift and timing can be adjusted infinitely.
The Multi-Air valve train has a mechanical camshaft lobe acting on a hydraulic pump located between the camshaft intake lobe and the intake valve. The pump provides oil under pressure to a two-way electro-hydraulic solenoid valve called the Variable Valve Actuator (VVA) Solenoid. The VVA Solenoid is electronically controlled during the specific intake cam lobe event by the Powertrain Control Module (PCM). During the event, the VVA Solenoid is commanded to either hold oil pressure or bleed oil. The Variable Valve Actuator (VVA) Solenoid is a normally open solenoid. The PCM provides 12 volts to close the solenoid. The position of the VVA Solenoid determines the intake valve timing and lift. This change on valve action is similar to creating a change in the camshaft lobe profile affecting the lift and duration of the valve opening. The Diagnostic Trouble Code (DTC) will be set when the PCM monitors the feedback current and determines that the Variable Valve Actuator (VVA) Solenoid is stuck.

OBDII Code P1061 - Cylinder 1 Oil Supply Solenoid Valve Stuck - AutoCodes.com
P1061 Code - Cylinder 1 Oil Supply Solenoid Valve Stuck

Need More Information on the Code?

Need more information on how to fix the P1061 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the P1061 code diagnosed by a professional: Find a repair shop in your area

Code P1061 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1061 code? Have you replaced any parts?
Any information is appreciated. Thanks