P2272 GMC Code - HO2S Signal Stuck Lean Bank 2 Sensor 2
Quick Answer
The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Bank 2 Sensor 2, Heated Oxygen Bank 2 Sensor 2 harness is open or shorted, Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P2272 GMC indicates HO2S Signal Stuck Lean Bank 2 Sensor 2.
- Common causes
- Common causes include Faulty Heated Oxygen Bank 2 Sensor 2, Heated Oxygen Bank 2 Sensor 2 harness is open or shorted, Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P2272 GMC Description
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM does not detect an HO2S voltage greater than 800 mV before accumulated mass airflow exceeds a calibrated value.
What are the Possible Causes of the DTC P2272 GMC?
- Faulty Heated Oxygen Bank 2 Sensor 2
- Heated Oxygen Bank 2 Sensor 2 harness is open or shorted
- Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection
- Low or high fuel system pressure
- Fuel contamination
- Faulty fuel injectors
- Exhaust gas leaks
- Engine vacuum leaks
How to Fix the DTC P2272 GMC?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
User Submitted Video
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P2272 GMC code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P2272 GMC code?
Need more information on how to fix the P2272 GMC code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2272 GMC code diagnosed by a professional: Find a repair shop in your area
Information for Specific GMC Models
- P2272 2014 GMC Sierra — HO2S Signal Stuck Lean Bank 2 Sensor 2
- P2272 2015 GMC Sierra — HO2S Signal Stuck Lean Bank 2 Sensor 2
- P2272 2016 GMC Sierra — HO2S Signal Stuck Lean Bank 2 Sensor 2
- P2272 2017 GMC Sierra — HO2S Signal Stuck Lean Bank 2 Sensor 2
- P2272 2018 GMC Sierra — HO2S Signal Stuck Lean Bank 2 Sensor 2
Frequently Asked Questions about P2272 GMC Code
What does the OBDII code P2272 mean on a GMC vehicle?
P2272 indicates that the downstream oxygen sensor (Bank 2, Sensor 2) is stuck in a lean position, meaning it’s not properly detecting the air-fuel mixture.
What are the common symptoms of code P2272 in a GMC?
Symptoms may include decreased fuel efficiency, rough idling, engine hesitation, and the check engine light turning on.
What causes the P2272 code on GMC vehicles?
Common causes include a faulty oxygen sensor, exhaust leaks, damaged wiring, or issues with the engine’s air-fuel mixture.
Can a bad oxygen sensor trigger code P2272?
Yes, a malfunctioning downstream oxygen sensor can cause this code by failing to provide accurate readings.
How can I diagnose code P2272 on my GMC?
Use an OBDII scanner to confirm the code, inspect the oxygen sensor and its wiring, check for exhaust leaks, and evaluate the air-fuel ratio.
Is it safe to drive with the P2272 code active?
While the vehicle may still be drivable, ignoring this code can lead to reduced fuel efficiency, performance issues, and potential damage to the catalytic converter.
How do I fix code P2272 on a GMC?
Repairs may include replacing the oxygen sensor, fixing exhaust leaks, repairing damaged wiring, or addressing engine performance issues.
What tools are needed to fix P2272 on a GMC?
You’ll need an OBDII scanner, basic hand tools, and possibly a multimeter to test the sensor and wiring connections.
Can an exhaust leak cause the P2272 code?
Yes, an exhaust leak near the downstream sensor can disrupt the sensor’s readings and cause it to show a lean signal.
How much does it cost to repair the P2272 code on a GMC?
Repair costs can range from $100 to $300, depending on whether the oxygen sensor or other components require replacement.
Discuss the causes and fixes for P2272 GMC OBDII Code
Code P2272 GMC comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
