AutoCodes – GMC – P0507 GMC

P0507 GMC Code - Idle Speed High

Quick Answer

The Engine Control Module (ECM) is the control center for the Throttle Actuator Control (TAC) system. Common causes include Dirty Throttle Body, Intake air leak, Throttle Body misadjusted or damaged. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P0507 GMC indicates Idle Speed High.
Common causes: Common causes include Dirty Throttle Body, Intake air leak, Throttle Body misadjusted or damaged.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs Step-by-Step Diagnostic Guide My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 33,248

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on Jun 29, 2022

Description
Step-by-Step Diagnostic Guide
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P0507 GMC Description

The Engine Control Module (ECM) is the control center for the Throttle Actuator Control (TAC) system. The ECM determines the driver's intent based on input from the accelerator pedal position sensors, then calculates the appropriate throttle response based on the throttle position sensors. The Direct Current (DC) motor, located in the Throttle Body Assembly, drives the throttle blade. In order to decrease idle speed, along with spark and fuel delivery changes the ECM commands the throttle closed reducing air flow into the engine and the idle speed decreases. In order to increase idle speed, the ECM commands the throttle plate open allowing more air to pass the throttle plate. The Diagnostic Trouble Code (DTC) will be set when the actual idle speed is approximately 188 RPM greater than the desired idle speed.

OBDII Code P0507 GMC - Idle Speed High - AutoCodes.com — P0507 GMC Code - Idle Speed High

What does this mean?

What are the Possible Causes of the DTC P0507 GMC?

Dirty Throttle Body
Intake air leak
Throttle Body misadjusted or damaged
Faulty Electric Throttle Actuator Motor (Located in the Throttle Body Assembly)
Electric Throttle Actuator Motor harness is open or shorted
Electric Throttle Actuator Motor circuit poor electrical connection

How to Fix the DTC P0507 GMC?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

If there are no intake leaks, clean the throttle body, adjust the engine idle, and clear the engine code. If the code persists you must replace the Electric Throttle Actuator Motor (Located in the Throttle Body Assembly).

The Engine Control Module (ECM) learns the idle position of the throttle plate to ensure the correct idle. Anytime the throttle body is cleaned or replaced, the ECM must learn the new throttle position. The idle may be unstable or a DTC may be set if the throttle position is not learned.
.
GMC Throttle Body Cleaning and Idle Learning Procedure

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0507 GMC code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0507 GMC code?

Need more information on how to fix the P0507 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0507 GMC code diagnosed by a professional: Find a repair shop in your area

Information for Specific GMC Models

P0507 2014 GMC Sierra — Idle Speed High
P0507 2015 GMC Sierra — Idle Speed High
P0507 2016 GMC Sierra — Idle Speed High
P0507 2017 GMC Sierra — Idle Speed High
P0507 2018 GMC Sierra — Idle Speed High

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.