AutoCodes – Generic – B2762

B2762 Code - Left C-Pillar Impact Acceleration Sensor

Quick Answer

The left side impact sensor 2 is located in the C-pillar area. Common causes include Faulty Left C-Pillar Impact Acceleration Sensor, Left C-Pillar Impact Acceleration Sensor harness is open or shorted, Left C-Pillar Impact Acceleration Sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: B2762 indicates Left C-Pillar Impact Acceleration Sensor.
Common causes: Common causes include Faulty Left C-Pillar Impact Acceleration Sensor, Left C-Pillar Impact Acceleration Sensor harness is open or shorted, Left C-Pillar Impact Acceleration Sensor circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 2,848

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Jul 13, 2022

Description
Possible Causes
How To Fix
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code B2762 Description

The left side impact sensor 2 is located in the C-pillar area. The impact sensors perform their own self-test using power supplied by the Occupant Restraint Controller (ORC) then communicates this status back to the ORC with periodic updates. The repair of this fault condition involves verifying the integrity of the wiring between the ORC and the sensor. The Occupant Restraint Controller (ORC) continuously communicates with the Left Side Impact Sensor 2 over the sensor signal circuit. The sensor communication and on board diagnostics are powered by the ORC signal.
This code will set, if the ORC and the Left Side Impact Sensor 2 do not establish and maintain valid data communications.

OBDII Code B2762 - Left C-Pillar Impact Acceleration Sensor - AutoCodes.com — B2762 Code - Left C-Pillar Impact Acceleration Sensor

What does this mean?

What are the Possible Causes of the DTC B2762?

Faulty Left C-Pillar Impact Acceleration Sensor
Left C-Pillar Impact Acceleration Sensor harness is open or shorted
Left C-Pillar Impact Acceleration Sensor circuit poor electrical connection
Faulty Occupant Restraint Controller (ORC)

How to Fix the DTC B2762?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2762 code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the B2762 code?

Need more information on how to fix the B2762 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B2762 code diagnosed by a professional: Find a repair shop in your area

Information for Specific Makes

B2762 Buick — Memory 2 Select Switch Circuit Low
B2762 Cadillac — Memory 2 Select Switch Circuit Low
B2762 Chevrolet — Memory 2 Select Switch Circuit Low
B2762 Chrysler — Left C-Pillar Impact Acceleration Sensor
B2762 Dodge — Left C-Pillar Impact Acceleration Sensor
B2762 GMC — Memory 2 Select Switch Circuit Low
B2762 Jeep — Left C-Pillar Impact Acceleration Sensor
B2762 Ram — Left C-Pillar Impact Acceleration Sensor

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about B2762 Code

1. What are the common symptoms of OBDII code B2762 (Left C-Pillar Impact Acceleration Sensor)?

The common symptoms include the airbag warning light being illuminated on the dashboard and potential issues with the airbag system's deployment in the event of a collision.

2. What causes OBDII code B2762 to trigger in a vehicle?

OBDII code B2762 is typically triggered when there is a malfunction or failure in the Left C-Pillar Impact Acceleration Sensor, which is responsible for detecting impact forces and deploying airbags when necessary.

3. How can I diagnose the issue related to OBDII code B2762?

To diagnose the issue, you can use an OBDII scanner to read the code and pinpoint the specific problem with the Left C-Pillar Impact Acceleration Sensor. Additionally, a visual inspection of the sensor and its wiring may help identify any visible damage or issues.

4. Is it safe to drive with OBDII code B2762 present?

It is not recommended to drive with OBDII code B2762 present, as this indicates a potential problem with the airbag system's functionality. Driving with this code could compromise the safety of the vehicle occupants in the event of a collision.

5. How can I repair OBDII code B2762 on my vehicle?

Repairing OBDII code B2762 usually involves replacing the Left C-Pillar Impact Acceleration Sensor with a new, functioning sensor. It is important to follow the manufacturer's guidelines and use quality replacement parts to ensure proper functionality.

6. Are there any DIY tips for fixing OBDII code B2762?

While it is possible to replace the Left C-Pillar Impact Acceleration Sensor yourself, it is recommended to have this repair done by a professional mechanic or technician with experience in airbag systems to ensure proper installation and calibration.

7. Can OBDII code B2762 be reset without fixing the underlying issue?

Resetting the code without fixing the underlying issue with the Left C-Pillar Impact Acceleration Sensor will only temporarily clear the warning light. The code will likely reappear until the root cause of the problem is addressed and repaired.

8. How much does it typically cost to repair OBDII code B2762?

The cost of repairing OBDII code B2762 can vary depending on the make and model of the vehicle, the labor rates of the repair shop, and the cost of the replacement sensor. On average, the repair cost can range from $200 to $500.

9. Are there any recalls related to OBDII code B2762 in certain vehicles?

It is recommended to check with the vehicle manufacturer or the National Highway Traffic Safety Administration (NHTSA) to see if there are any recalls related to OBDII code B2762 in specific vehicle models. Recalls related to airbag systems are taken seriously due to safety concerns.

10. Can OBDII code B2762 affect the overall safety of the vehicle?

Yes, OBDII code B2762 can affect the overall safety of the vehicle by potentially compromising the proper functioning of the airbag system. It is crucial to address this issue promptly to ensure the safety of the vehicle occupants in the event of a collision.