Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
To diagnose the B2594 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The Power Sliding Door (PSD) Module supplies 12 volts to the latch actuator on a circuit through the sliding door contacts which release the power sliding door latch. Also, a 5-volt reference is supplied to the position sensor on circuit. The PSD detent switch circuit is monitored for a momentary ground signaling the rear latch is released. This circuit is monitored through the sliding door contacts and will open when the contacts separate. When the momentary PSD detent switch ground is detected by the PSD module, power is supplied to the drive assembly actuator clutch and motor which opens the power sliding door. As the power sliding door is opened, the position sensor is used to track the power sliding door movement and position. If there is no movement detected by the PSD module after an unlatch occurred, DTC B2594 sets.
Need more information on how to fix the B2594 code? Get Access to Factory Service Manuals
Get the B2594 code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2594 code? Have you replaced any parts?
Any information is appreciated. Thanks