AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Lincoln - B2594 Lincoln

B2594 Lincoln Code - No Movement Was Detected After An Unlatch During A Power Open

- Code Popularity: 308 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2594 Lincoln?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Power Sliding Door (PSD) Detent Switch
  • Faulty Power Sliding Door (PSD) Drive Assembly Actuator
  • Faulty Power Sliding Door (PSD) Module
⚠ Does your Lincoln have Safety Recalls? → Check here

How to Fix the DTC B2594 Lincoln?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B2594 Lincoln Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2594 Lincoln code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B2594 Lincoln Description

The Power Sliding Door (PSD) Module supplies 12 volts to the latch actuator on a circuit through the sliding door contacts which release the power sliding door latch. Also, a 5-volt reference is supplied to the position sensor on circuit. The PSD detent switch circuit is monitored for a momentary ground signaling the rear latch is released. This circuit is monitored through the sliding door contacts and will open when the contacts separate. When the momentary PSD detent switch ground is detected by the PSD module, power is supplied to the drive assembly actuator clutch and motor which opens the power sliding door. As the power sliding door is opened, the position sensor is used to track the power sliding door movement and position. If there is no movement detected by the PSD module after an unlatch occurred, DTC B2594 sets.

OBDII Code B2594 Lincoln - No Movement Was Detected After An Unlatch During A Power Open - AutoCodes.com
B2594 Lincoln Code - No Movement Was Detected After An Unlatch During A Power Open

Need More Information on the Code?

Need more information on how to fix the B2594 Lincoln code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B2594 Lincoln code diagnosed by a professional: Find a repair shop in your area

Code B2594 Lincoln comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2594 Lincoln code? Have you replaced any parts?
Any information is appreciated. Thanks