AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B1907

B1907 Code - Short to Ground in Front Pretensioner Squib Left Circuit

- Code Popularity: 9,543 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Dec 07, 2022
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1907 Possible Causes

  • Faulty Front Seat Outer Belt Assembly Left (LH) (Front Pretensioner Squib Left)
  • Front Seat Outer Belt Assembly Left is open or shorted
  • Front Seat Outer Belt Assembly Left poor electrical connection
  • Faulty Center Airbag Sensor Assembly

|How do I Fix the Code B1907?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Car have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1907?

Labor: 1.0

The cost of diagnosing the B1907 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1907 Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1907 Description

The Front Pretensioner Squib Left (LH) Circuit consists of the Center Airbag Sensor Assembly and Front Seat Outer Belt Assembly Left (LH). This circuit instructs the Supplemental Restraint System (SRS) to deploy when the deployment conditions are met. The Diagnostic Trouble Code (DTC) is recorded when a malfunction is detected in the Front Pretensioner Squib Left Circuit.

OBDII Code B1907 - Short to Ground in Front Pretensioner Squib Left Circuit - AutoCodes.com
B1907 Code - Short to Ground in Front Pretensioner Squib Left Circuit

|Need More Information on the B1907 Code?

Need more information on how to fix the B1907 code? Get Access to Factory Service Manuals

|Information for Specific Makes

|Need Help with the B1907 Code?

Get the B1907 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1907 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1907 code? Have you replaced any parts?
Any information is appreciated. Thanks