Side Airbag Sensor Left harness is open or shorted
Side Airbag Sensor Left circuit poor electrical connection
Faulty Center Airbag Sensor Assembly
|How do I Fix the Code B1647?
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost of diagnosing the B1647 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
|What are Code B1647 Possible Symptoms?
Air Bag Warning Light ON
|Code B1647 Description
The Side Collision Sensor Left (LH) circuit (to determine deployment of the Front Seat Side Airbag Assembly LH and Curtain Shield Airbag Assembly LH) is composed of the Center Airbag Sensor Assembly, Side Airbag Sensor LH, and Rear Airbag Sensor LH. The Side Airbag Sensor LH and Rear Airbag Sensor LH detect impacts to the vehicle and send signals to the Center Airbag Sensor Assembly to determine if the airbag should be deployed. The Diagnostic Trouble Code (DTC) is stored when a malfunction is detected in the Side Collision Sensor LH circuit (to determine deployment of the Front Seat Side Airbag Assembly LH and Curtain Shield Airbag Assembly LH).
B1647 Code - Lost Communication With Side Satellite Sensor Bus Left
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1647 code? Have you replaced any parts? Any information is appreciated. Thanks
