AutoCodes - Gmc - B0961 GMC

B0961 GMC Code - Parking Aid Rear Sensor 1 Right Corner Circuit

Repair Importance Level: 1/3
Repair Difficulty Level: 2/3
Table of contents

|B0961 GMC code possible causes

  • Faulty Parking Aid Rear Sensor 1 Right Corner
  • Parking Aid Rear Sensor 1 Right Corner harness is open or shorted
  • Parking Aid Rear Sensor 1 Right Corner circuit poor electrical connection

|How do I fix the B0961 GMC code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|B0961 GMC code tech notes

B0961 01 Parking Aid Rear Sensor 1 Right Corner Circuit Short to Battery
B0961 06 Parking Aid Rear Sensor 1 Right Corner Circuit Short to Ground or Open
B0961 08 Parking Aid Rear Sensor 1 Right Corner Circuit Signal Invalid
B0961 21 Parking Aid Rear Sensor 1 Right Corner Circuit Incorrect Period

|Cost of diagnosing the B0961 GMC code

Labor: 1.0

The cost of diagnosing the B0961 GMC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B0961 GMC code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|B0961 GMC code description

The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. Each object sensor is a 3-wire sensor that is both a transmitter and a receiver that comprises a signal circuit, a low reference circuit, and an 8-volt supply voltage circuit. The rear object control module supplies 8 volts to the object sensors via the object sensor supply voltage circuit and provides ground via the low reference circuit. The rear object control module triggers the sensors in a sequential loop and after each sensor transmits, the rear object control module uses the echo or signal return to calculate the distance and position of an object from the rear bumper. The rear object control module directly controls the Rear Parking Assist (RPA) display. The RPA consists of 2 amber and one red LED that indicates the range of an object from the rear bumper. The rear object control module will also use an audible warning by sending a low speed GMLAN message to the radio.
OBDII Code B0961 Gmc - Parking Aid Rear Sensor 1 Right Corner Circuit - AutoCodes.com

|Need more information with the B0961 GMC code?

Need more information on how to fix the B0961 GMC code?
Get Access to Factory Service Manuals

|Need help with a B0961 GMC code?

Get the B0961 Gmc code diagnosed by a professional: Find a repair shop in your area

|B0961 GMC code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B0961 Gmc code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 1
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?