B001B GMC - Passenger Seat Belt Anchor Pretensioner Deployment
Tech notesDTC B001B 01 Passenger Seat Belt Anchor Pretensioner Deployment Loop Short to Battery
DTC B001B 02 Passenger Seat Belt Anchor Pretensioner Deployment Loop Short to Ground
DTC B001B 04 Passenger Seat Belt Anchor Pretensioner Deployment Loop Open
DTC B001B 0D Passenger Seat Belt Anchor Pretensioner Deployment Loop High Resistance
DTC B001B 0E Passenger Seat Belt Anchor Pretensioner Deployment Loop Low Resistance
B001b Gmc DescriptionDuring a side or frontal crash of sufficient force, the Inflatable Restraint Sensing and Diagnostic Module (SDM) will allow current to flow through the deployment loop in order to deploy an air bag or pretensioner. There are 2 shorting bars which will short together control circuits, when the connector is disconnected. This will help to prevent unwanted deployment of the air bag or pretensioner during servicing.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Need more help?Do you need more help with the B001b Gmc code? Ask a question to our users or find an automotive repair shop near you to help fix the OBDII code
B001B GMC CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B001b Gmc code? Have you replaced any parts?
Any information is appreciated. Thanks