AutoCodes - Ford - U3003 FORD

U3003 FORD Code - ABS Module Battery Voltage

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U3003 FORD code possible causes

  • Faulty Anti-Lock Brake System (ABS) Module
  • Anti-Lock Brake System (ABS) Module harness is open or shorted
  • Anti-Lock Brake System (ABS) Module circuit poor electrical connection

|How do I fix the U3003 FORD code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|U3003 FORD code tech notes

This DTC sets in continuous memory and on-demand if the voltage supplied to the ABS module falls below 10 volts or if the power latch mode counter reaches a predetermined number.

|Cost of diagnosing the U3003 FORD code

Labor: 1.0

The cost of diagnosing the U3003 FORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U3003 FORD code possible symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

|U3003 FORD code description

The Anti-Lock Brake System (ABS) Module, hydraulic pump and solenoid valves require an operating voltage that is between 10 and 17 volts. The ABS module receives this voltage from the BJB. The ABS module has a single ground circuit located in the engine compartment wiring harness. Excessive resistance or an open in one or more of these circuits, a discharged battery or a inoperative charging system results in the ABS module setting a DTC.
Internally to the ABS module, the ignition voltage supply circuit is used as a redundant back up for the battery voltage supply circuit in case the battery voltage supply circuit is interrupted. If the battery voltage supply circuit is interrupted, the ABS module immediately shuts off and does not enter the power latch mode. The module uses the power latch mode to write certain parameters (such as learned offsets numbers) to non-volatile memory. At the beginning of each ignition cycle, a counter value is increased by 1 after a specified vehicle speed has been reached and a specified time has elapsed. When the ABS module enters the power latch mode, this counter is reset to 0.
OBDII Code U3003 Ford - ABS Module Battery Voltage - AutoCodes.com

|Need more information with the U3003 FORD code?

Need more information on how to fix the U3003 FORD code?
Get Access to Factory Service Manuals

|Need help with a U3003 FORD code?

Get the U3003 Ford code diagnosed by a professional: Find a repair shop in your area

|U3003 FORD code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U3003 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?