AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Buick - U2615 Buick

U2615 Buick Code - Auxiliary Transmission Fluid Pump Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2

- Code Popularity: 275 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jun 18, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|Code U2615 Buick Possible Causes

  • Faulty Auxiliary Transmission Fluid Pump Control Module
  • Auxiliary Transmission Fluid Pump Control Module harness is open or shorted
  • Auxiliary Transmission Fluid Pump Control Module circuit poor electrical connection
  • Faulty Hybrid/EV Powertrain Control Module 2

|How do I Fix the Code U2615 Buick?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Buick have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code U2615 Buick?

Labor: 1.0

The cost of diagnosing the U2615 Buick code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code U2615 Buick Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|Code U2615 Buick Description

Devices connected to the serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the devices. The devices have prerecorded information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are supervised and also, some periodic messages are used by the receiver device as an availability indication of the transmitter device. Each message contains the identification number of the transmitter device.
This diagnostic is used to check the loss of communication with the Hybrid/EV Powertrain Control Module 2 on a high-speed General Motors Local Area Network (GMLAN) bus. The Battery Energy Control Module supervises a periodic serial data message to check the communication status of the Hybrid/EV Powertrain Control Module 2. If this message is not received within 400 ms, the Battery Energy Control Module increases its fail count. When this fail count is over X Cal Value (7) during Y Cal Value (10 samples), the diagnostic status of this code is set to Failed and transmitted over high voltage energy high-speed GMLAN bus to the Hybrid/EV Powertrain Control Module 2.
The Diagnostic Trouble Code (DTC) will set when a supervised periodic message that includes the transmitter device availability has not been received within 400 ms.

OBDII Code U2615 Buick - Auxiliary Transmission Fluid Pump Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2 - AutoCodes.com
U2615 Buick Code - Auxiliary Transmission Fluid Pump Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2

|Need More Information on the U2615 Buick Code?

Need more information on how to fix the U2615 Buick code? Get Access to Factory Service Manuals

|Need Help with the U2615 Buick Code?

Get the U2615 Buick code diagnosed by a professional: Find a repair shop in your area

|Code U2615 Buick comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U2615 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks