AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Buick - U2614 BUICK

U2614 BUICK Code - Drive Motor 2 Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2

- Code Popularity: 206 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Updated Jun 18, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|U2614 BUICK code possible causes

  • Faulty Drive Motor 2 Control Module
  • Drive Motor 2 Control Module harness is open or shorted
  • Drive Motor 2 Control Module circuit poor electrical connection
  • Faulty Hybrid/EV Powertrain Control Module 2

|How do I fix code U2614 BUICK code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing U2614 BUICK code

Labor: 1.0

The cost of diagnosing the U2614 BUICK code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are U2614 BUICK code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|U2614 BUICK code description

Devices connected to the serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the devices. The devices have prerecorded information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are supervised and also, some periodic messages are used by the receiver device as an availability indication of the transmitter device. Each message contains the identification number of the transmitter device.
This diagnostic is used to check the loss of communication with the Hybrid/EV Powertrain Control Module 2 on a high-speed General Motors Local Area Network (GMLAN) bus. The Battery Energy Control Module supervises a periodic serial data message to check the communication status of the Hybrid/EV Powertrain Control Module 2. If this message is not received within 400 ms, the Battery Energy Control Module increases its fail count. When this fail count is over X Cal Value (7) during Y Cal Value (10 samples), the diagnostic status of this code is set to Failed and transmitted over high voltage energy high-speed GMLAN bus to the Hybrid/EV Powertrain Control Module 2.
The Diagnostic Trouble Code (DTC) will set when a supervised periodic message that includes the transmitter device availability has not been received within 400 ms.

OBDII Code U2614 Buick - Drive Motor 2 Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2 - AutoCodes.com
Drive Motor 2 Control Module Lost Communication With Hybrid/EV Powertrain Control Module 2

|Need more information with the U2614 BUICK code?

Need more information on how to fix the U2614 BUICK code?
Get Access to Factory Service Manuals

|Need help with a U2614 BUICK code?

Get the U2614 Buick code diagnosed by a professional: Find a repair shop in your area

|U2614 BUICK code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U2614 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks