AutoCodes - Buick - U2608 BUICK

U2608 BUICK Code - Electric A/C Compressor Control Module Lost Communication With Hybrid/EV Powertrain Control Module

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U2608 BUICK code possible causes

  • Faulty Hybrid/EV Powertrain Control Module
  • Hybrid/EV Powertrain Control Module harness is open or shorted
  • Hybrid/EV Powertrain Control Module circuit poor electrical connection
  • Faulty Electric A/C Compressor Control Module

|How do I fix the U2608 BUICK code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the U2608 BUICK code

Labor: 1.0

The cost of diagnosing the U2608 BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U2608 BUICK code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|U2608 BUICK code description

Devices connected to the serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the devices. The devices have prerecorded information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are supervised and also, some periodic messages are used by the receiver device as an availability indication of the transmitter device. Each message contains the identification number of the transmitter device.
This diagnostic is used to check the loss of communication with the Hybrid/EV Powertrain Control Module on a high-speed General Motors Local Area Network (GMLAN) bus. The Battery Energy Control Module supervises a periodic serial data message to check the communication status of the Hybrid/EV Powertrain Control Module. If this message is not received within 400 ms, the Battery Energy Control Module increases its fail count. When this fail count is over X Cal Value (7) during Y Cal Value (10 samples), the diagnostic status of this code is set to Failed and transmitted over high voltage energy high-speed GMLAN bus to the Hybrid/EV Powertrain Control Module.
The Diagnostic Trouble Code (DTC) will set when a supervised periodic message that includes the transmitter device availability has not been received within 400 ms.
OBDII Code U2608 Buick - Electric A/C Compressor Control Module Lost Communication With Hybrid/EV Powertrain Control Module - AutoCodes.com

|Need more information with the U2608 BUICK code?

Need more information on how to fix the U2608 BUICK code?
Get Access to Factory Service Manuals

|Need help with a U2608 BUICK code?

Get the U2608 Buick code diagnosed by a professional: Find a repair shop in your area

|U2608 BUICK code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U2608 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?