AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - U2105

U2105 Code - Lost Communications with Engine Control Module

- Code Popularity: 14,215 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC U2105?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Engine Control Module (ECM)
  • Engine Control Module harness is open or shorted
  • Engine Control Module circuit poor electrical connection
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC U2105?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for U2105 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the U2105 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code U2105 Description

Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits. The messages are supervised and also, and some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module. A module with a CAN serial data circuit malfunction or which loses power during the current ignition cycle will have a Loss of Communication Diagnostic Trouble Code (DTC) set by other modules that depend on information from that failed module. If any of the CAN circuits are shorted to battery voltage, ground, or between them no communication is possible on the CAN serial data bus, a DTC will be set.

OBDII Code U2105 - Lost Communications with Engine Control Module - AutoCodes.com
U2105 Code - Lost Communications with Engine Control Module

Need More Information on the Code?

Need more information on how to fix the U2105 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the U2105 code diagnosed by a professional: Find a repair shop in your area

Code U2105 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U2105 code? Have you replaced any parts?
Any information is appreciated. Thanks