AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - U2100 FORD

U2100 FORD Code - Initial Configuration Not Complete

- Code Popularity: 16,983 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jun 15, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|U2100 FORD code possible causes

  • Seat calibration routine did not complete successfully
  • Faulty Driver Front Seat Module (DSM)
  • Driver Front Seat Module harness is open or shorted
  • Driver Front Seat Module circuit poor electrical connection

|How do I fix code U2100 FORD code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|Cost of diagnosing U2100 FORD code

Labor: 1.0

The cost of diagnosing the U2100 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are U2100 FORD code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|U2100 FORD code description

This Diagnostic Trouble Code (DTC) can be set in the Driver Front Seat Module (DSM) if the seat calibration routine has not been completed successfully.

OBDII Code u2100 ford - Initial Configuration Not Complete - AutoCodes.com
U2100 FORD Code - Initial Configuration Not Complete

|Need more information with the U2100 FORD code?

Need more information on how to fix the U2100 FORD code? Get Access to Factory Service Manuals

|Need help with a U2100 FORD code?

Get the u2100 ford code diagnosed by a professional: Find a repair shop in your area

|U2100 FORD code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the u2100 ford code? Have you replaced any parts?
Any information is appreciated. Thanks