| All About OBDII Engine Codes
AutoCodes - Mercury - U1950 MERCURY

U1950 MERCURY Code - UPB Communication Bus Fault

- Code Popularity: 1,504 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By - Updated Jun 09, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|U1950 MERCURY code possible causes

  • UBP Bus wiring intermittently open/shorted to power or ground
  • Faulty / intermittent electrical connection at any of the controllers on the UBP network

|How do I fix code U1950 MERCURY code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|U1950 MERCURY code tech notes

This is typically an electrical wiring connection issue at one of the controllers being monitored by the manufacturer.
It can occur if:
Wiring to the module becomes shorted by the module.
Wiring to the module becomes shorted between modules, such as where wires are routed on passenger side floor rails and become water soaked. Watch for water intrusion when this occurs.

|Cost of diagnosing U1950 MERCURY code

Labor: 1.0

The cost of diagnosing the U1950 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the U1950 MERCURY code detected?

When the controllers are unable to communicate with each other at any time while the ignition switch is turned to the “Run” position.

|What are U1950 MERCURY code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine won’t start – won’t crank
  • ABS Warning Light ON
  • Transmission may shift erratically
  • Cluster won’t register any reading

|U1950 MERCURY code description

The Anti-lock Brake System (ABS) module, the Powertrain Control Module (PCM), the Transmission Control Module (TCM), the instrument cluster and the parking aid module are just some of modules that communicate over the UART Based Protocol network bus or UBP Bus. This is a high-speed bus communication system and is not fault tolerant, which means any type of intermittent/loose connection between these 3 controllers will cause communication to stop. When the PCM, ABS module and instrument cluster are unable to communicate with each other at any time while the ignition switch is turned on, code U1950 will set.

OBDII Code U1950 Mercury - UPB Communication Bus Fault -
U1950 MERCURY Code - UPB Communication Bus Fault

|Need more information with the U1950 MERCURY code?

Need more information on how to fix the U1950 MERCURY code?
Get Access to Factory Service Manuals

|Need help with a U1950 MERCURY code?

Get the U1950 Mercury code diagnosed by a professional: Find a repair shop in your area

|U1950 MERCURY code comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U1950 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks