Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
This is typically an electrical wiring connection issue at one of the controllers being monitored by the manufacturer.
It can occur if:
Wiring to the module becomes shorted by the module.
Wiring to the module becomes shorted between modules, such as where wires are routed on passenger side floor rails and become water soaked. Watch for water intrusion when this occurs.
The cost of diagnosing the U1950 Lincoln code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When the controllers are unable to communicate with each other at any time while the ignition switch is turned to the “Run” position.
The Anti-lock Brake System (ABS) module, the Powertrain Control Module (PCM), the Transmission Control Module (TCM), the instrument cluster and the parking aid module are just some of modules that communicate over the UART Based Protocol network bus or UBP Bus. This is a high-speed bus communication system and is not fault tolerant, which means any type of intermittent/loose connection between these 3 controllers will cause communication to stop. When the PCM, ABS module and instrument cluster are unable to communicate with each other at any time while the ignition switch is turned on, code U1950 will set.
Need more information on how to fix the U1950 Lincoln code? Get Access to Factory Service Manuals
Get the U1950 Lincoln code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U1950 Lincoln code? Have you replaced any parts?
Any information is appreciated. Thanks