AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mercury - U1901 Mercury

U1901 Mercury Code - CAN Network No. 2 Communication Bus Fault - Receive Error

- Code Popularity: 1,275 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jun 09, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|Code U1901 Mercury Possible Causes

  • Faulty Stability Control Sensor Cluster
  • Stability Control Sensor Cluster harness is open or shorted
  • Stability Control Sensor Cluster circuit poor electrical connection

|How do I Fix the Code U1901 Mercury?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Mercury have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code U1901 Mercury?

Labor: 1.0

The cost of diagnosing the U1901 Mercury code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code U1901 Mercury Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

|Code U1901 Mercury Description

The yaw rate sensor, roll rate sensor, lateral accelerometer and longitudinal accelerometer are contained in one module called the stability control sensor cluster. The sensor cluster measures the vehicle acceleration, roll rate and yaw rate, then sends the signal through a secondary, dedicated controller area network (CAN2) bus to the ABS module. The ABS module compares the information from the sensor cluster to information it receives from other sensors (brake pedal input or steering wheel rotation sensor) to determine how valid the information is and to determine if a roll-over event is about to occur.
The ABS module provides power to the sensor cluster and ground. The sensor cluster and the ABS module communicate. An open circuit or a short to power or ground on any one of these 4 circuits will cause the ABS module to set a DTC. Also, if the sensor cluster is not mounted in the correct position, with the electrical connector facing the passenger seat, the ABS module will also set DTCs.

OBDII Code U1901 Mercury - CAN Network No. 2 Communication Bus Fault - Receive Error - AutoCodes.com
U1901 Mercury Code - CAN Network No. 2 Communication Bus Fault - Receive Error

|Need More Information on the U1901 Mercury Code?

Need more information on how to fix the U1901 Mercury code? Get Access to Factory Service Manuals

|Need Help with the U1901 Mercury Code?

Get the U1901 Mercury code diagnosed by a professional: Find a repair shop in your area

|Code U1901 Mercury comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U1901 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks