AutoCodes - Buick - U1862 BUICK

U1862 BUICK Code - Battery Energy Control Module Lost Communication With Serial Data Gateway Module

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U1862 BUICK code possible causes

  • Faulty Serial Data Gateway Module
  • Serial Data Gateway Module harness is open or shorted
  • Serial Data Gateway Module circuit poor electrical connection

|How do I fix the U1862 BUICK code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the U1862 BUICK code

Labor: 1.0

The cost of diagnosing the U1862 BUICK code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U1862 BUICK code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|U1862 BUICK code description

Modules connected to the Controller Area Network (CAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. The modules have prerecorded information about what messages are needed to be exchanged on the serial data circuits. The messages are supervised and also, some periodic messages are used by the receiver module as an availability indication of the transmitter module. Each message contains the identification number of the transmitter module. A module with a CAN serial data circuits malfunction or which loses power during the current ignition cycle will have a Loss of Communication Diagnostic Trouble Code (DTC) set by other modules that depend on information from that failed module. If any of the CAN circuit are shorted to battery voltage, ground, or between them no communication is possible on the CAN serial data bus, a Diagnostic Trouble Code will set.
OBDII Code U1862 Buick - Battery Energy Control Module Lost Communication With Serial Data Gateway Module - AutoCodes.com

|Need more information with the U1862 BUICK code?

Need more information on how to fix the U1862 BUICK code?
Get Access to Factory Service Manuals

|Need help with a U1862 BUICK code?

Get the U1862 Buick code diagnosed by a professional: Find a repair shop in your area

|U1862 BUICK code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U1862 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?