AutoCodes - Cadillac - U182A CADILLAC

U182A CADILLAC Code - Hybrid/EV Powertrain Control Module Lost Communication With Battery Energy Control Module On Powertrain Expansion CAN Bus

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U182A CADILLAC code possible causes

  • Faulty Hybrid/EV Powertrain Control Module
  • Hybrid/EV Powertrain Control Module harness is open or shorted
  • Hybrid/EV Powertrain Control Module circuit poor electrical connection
  • Faulty Body Control Module (BCM)

|How do I fix the U182A CADILLAC code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the U182A CADILLAC code

Labor: 1.0

The cost of diagnosing the U182A CADILLAC code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U182A CADILLAC code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|U182A CADILLAC code description

Devices connected to the powertrain high-speed General Motor Local Area Network (GMLAN) serial data circuits monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the devices. The devices have prerecorded information about what messages are needed to be exchanged on the serial data circuits, for each virtual network. The messages are supervised and also, some periodic messages are used by the receiver device as an availability indication of the transmitter device. Each message contains the identification number of the transmitter device.
The Battery Energy Control Module is internal to the Hybrid/EV Powertrain Control Module 2. Communication diagnostics for the serial data, including device power and ground as well as the wakeup circuits for the K16 Battery Energy Control Module is diagnosed from external sources only to the Hybrid/EV Powertrain Control Module 2 connector because any circuit fault condition within the Hybrid/EV Powertrain Control Module 2 will cause a complete replacement.
The Diagnostic Trouble Code (DTC) will set when a supervised periodic message that includes the transmitter device availability has not been received.
OBDII Code U182a Cadillac - Hybrid/EV Powertrain Control Module Lost Communication With Battery Energy Control Module On Powertrain Expansion CAN Bus - AutoCodes.com

|Need more information with the U182A CADILLAC code?

Need more information on how to fix the U182A CADILLAC code?
Get Access to Factory Service Manuals

|Need help with a U182A CADILLAC code?

Get the U182a Cadillac code diagnosed by a professional: Find a repair shop in your area

|U182A CADILLAC code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U182a Cadillac code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?