AutoCodes - Dodge - U11F1 DODGE

U11F1 DODGE Code - Lost Communication With Right Impact Pressure Sensor

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U11F1 DODGE code possible causes

  • Faulty Right Impact Pressure Sensor
  • Right Impact Pressure Sensor harness is open or shorted
  • Right Impact Pressure Sensor circuit poor electrical connection
  • Faulty Occupant Restraint Controller (ORC)

|How do I fix the U11F1 DODGE code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the U11F1 DODGE code

Labor: 1.0

The cost of diagnosing the U11F1 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U11F1 DODGE code possible symptoms?

  • Air Bag Warning Light ON

|U11F1 DODGE code description

The impact sensors perform their own self-test using power supplied by the Occupant Restraint Controller (ORC) then communicate this status back to the ORC with periodic updates. The repair of this fault condition involves verifying the integrity of the wiring between the ORC and the sensor. This code will set, if the ORC and the Passenger Door Pressure Sensor do not establish and maintain valid data communications. The Diagnostic Trouble Code (DTC) will become Active after the fault has set for a minimum of 2.5 seconds. The DTC will go to Stored after the ORC to Passenger Door Pressure Sensor communication fault has been removed or the suspect pressure sensor has been replaced for 2.5 seconds. The Airbag Warning Lamp (AWL) will set in the instrument cluster.
OBDII Code U11f1 Dodge - Lost Communication With Right Impact Pressure Sensor -

|Need more information with the U11F1 DODGE code?

Need more information on how to fix the U11F1 DODGE code? Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Need help with a U11F1 DODGE code?

Get the U11f1 Dodge code diagnosed by a professional: Find a repair shop in your area

|U11F1 DODGE code comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U11f1 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
1=Easy 2=Moderate 3=Hard What is this?