AutoCodes
 
OBDII Code List
 
U1110 DODGE

U1110 DODGE - SCP Invalid or Missing Data for Primary Id

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

U1110 DODGE Possible Causes

  • Faulty / intermittent ignition switch connections
  • J1850 / SCP / CAN Bus wiring intermittently open, shorted to power or ground
  • Faulty / intermittent connection at the Powertrain Control Module (PCM)
  • Faulty / intermittent connection at the Anti-Lock Brake Module (ABS)

First diagnose U1110 DODGE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

U1110 DODGE Tech Notes

This is typically an electrical wiring connection issue at one of the controllers being monitored by the manufacturer.
It can occur if:
Someone changes a battery while the ignition switch is left on, that is, left in the “Run” position.
Someone flashes/upgrades their engine controller – other modules unable to communicate with PCM during this process – this will set U1110 at a multitude of controllers on the vehicle – all false codes. Erase and carry on.
May need to disconnect both battery cables and touch them together for 15 seconds. Reattach battery cables, positive first, then negative and see if a soft reset helps.

Cost of diagnosing the U1110 DODGE code

    Labor: 1.0

    The cost of diagnosing the U1110 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the U1110 DODGE code detected?

When the PCM is unable to communicate with any other controller on the bus network at any time while the ignition switch is in the “Run” position.

U1110 DODGE Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine cranks but may not start – may be intermittent
  • May or may not be able to communicate with a scan tool / depends on problem

U1110 Dodge Description

This is a manufacturer specific fault code and can be used for several different faults, depending upon what the manufacturer wants to use it for. Controllers communicate over the Serial Communication Protocol (SCP) bus network, also known as J1850 bus, or Controller Area Network or CAN Bus. These bus communication systems may or may not be fault tolerant, which means any type of intermittent/loose connection between these controllers could cause communication to stop. When these controllers are unable to communicate with each other at any time while the ignition switch is turned on, code U1110 will set.
OBDII Code U1110 Dodge - SCP Invalid or Missing Data for Primary Id - AutoCodes.com

U1110 DODGE More Information

Need more information on how to fix the U1110 DODGE code?
Get Access to Factory Service Manuals

Need more help?

Get the U1110 Dodge code diagnosed by a professional: Find a repair shop in your area

Related Information

U1110 DODGE Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the U1110 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧