AutoCodes - Saab - U1016 SAAB

U1016 SAAB Code - Invalid Or Missing Data For Powertrain/Engine Control Module

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|U1016 SAAB code possible causes

  • Faulty Powertrain/Engine Control Module (PCM/ECM)
  • Powertrain/Engine Control Module harness is open or shorted
  • Powertrain/Engine Control Module circuit poor electrical connection

|How do I fix the U1016 SAAB code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|U1016 SAAB code tech notes

This is typically an electrical wiring connection issue at one of the controllers being monitored by the manufacturer.
It can occur if:
Someone changes a battery while the ignition switch is left on, that is, left in the RUN position.
Someone flashes/upgrades their engine controller – other modules unable to communicate with the PCM during this process – this will set U1016 at a multitude of controllers on the vehicle – all false codes. Erase and carry on.

|Cost of diagnosing the U1016 SAAB code

Labor: 1.0

The cost of diagnosing the U1016 SAAB code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are U1016 SAAB code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine cranks but may not start – may be intermittent
  • May or may not be able to communicate with a scan tool / depends on problem

|U1016 SAAB code description

Modules connected to the class 2 serial data circuit monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. When a module receives a message for a critical operating parameter, the module records the identification number of the module which sent the message for the state of health monitoring/node alive messages. A critical operating parameter is one which, when not received, requires that the module use a default value for that parameter. Once an identification number is learned by a module, it will monitor for that module node alive message. Each module on the class 2 serial data circuit is required to send a Node Alive message every 2 seconds. When no message is detected from a learned identification number for 5 seconds, a Diagnostic Trouble Code (DTC) U1016 is set.
OBDII Code U1016 Saab - Invalid Or Missing Data For Powertrain/Engine Control Module - AutoCodes.com

|Need more information with the U1016 SAAB code?

Need more information on how to fix the U1016 SAAB code? Get Access to Factory Service Manuals

|Need help with a U1016 SAAB code?

Get the U1016 Saab code diagnosed by a professional: Find a repair shop in your area

|U1016 SAAB code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U1016 Saab code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?